Using an LCD on WiiLogy
LCD Pinout for a 16X2 Serial LCD
PIN on LCD PIN on Arduino
VDD ---------------------------- VCC
GND ---------------------------- GND
RX -------------------------- TX
LCD Instructions
- To activate the LCD DISARM the motors and push full forward on cyclic stick and full right on Yaw.
- To cycle through the different settings, use forward and rear cyclic (Down and Up Elevator)
- To change a setting use left and right cyclic stick (Left and Right Ailerons)
- To quit LCD config use full Forward on cyclic stick and full left Yaw.
| < Prev | Next > |
|---|
